With the numerous points we have to choose from for our steroid injections most will find the glutes and lateral (side) deltoid head to be the most comfortable and convenient points of administration. Injection sites such as calves and traps are highly warned against; although in terms of adequate injection sites they are fine, they can produce a fair amount of pain in the individual. No matter where you choose to inject always practice sanitary methods; do not reuse needles or syringes, clean the area thoroughly before injection and always sterilize with alcohol beforehand.
first time using this lab, i'm on a Geneza test p only cycle. i'm taking 3mg eod, i'm about 3 weeks in and not really feeling the boost. I had a friend over a few days ago before we hit gym and he noticed that when I was drawing there was a little cloud stuck to pin tip which made a little difficult to draw and little granules on bottom when shaken. I never noticed because it's clear for most part, he said its going bad. I literally just ordered last month. is this normal and my injection sites occasionally get a lump and warm with pain. i do know there is some pain on site but he said it shouldn't be like I have from last pin. any suggestions ??????
The two most commonly used polyamide grades by far are PA6 and PA66. The remaining members of the polyamide family are primarily used in applications that require unusually high service temperatures or tolerance of moist conditions. Bio-based and transparent (amorphous) PA grades are also available. In machine design purposes PA is often reinforced with glass or - in case of highly demanding applications - with carbon-fiber. Reinforcement changes the characteristics of the material and its applications considerably and therefore I’ll write a separate article on them later. This article focuses on unfilled PA6 and PA66.